R-Tech I-CUT100P Especificações

www.r-techwelding.co.uk Tel: 01452 733933 Fax 01452 733939 PLASMA I-CUT100P INVERTER PLASMA CUTTER OPERATION INSTRUCTIONS Version 2014-1

This regulates the air pressure as displayed in gauge on front of machine. To adjust pressure pull knob outwards and turn to adjust pressure, once cor

Operating Machine Please ensure all torch consumables are tight before use 1. Ensure machine has been setup as previously stated2. Turn on the machine

Replacing torch consumables WARNING! ELECTRIC SHOCK CAN KILL Please ensure machine is turned off before changing consumables If cutting performanc

Maintenance Routine and periodic maintenance WARNING! ELECTRIC SHOCK CAN KILL Turn the input power OFF at the mains switch & fuse box and r

3. No output - Power light is lit - Warning light is lit Welding application may have exceeded recommended duty cycle, allow machine to cool down un

Plasma Torch Consumables parts list R-Tech Torch Spares Plasma I-CUT 100P Part No. Electrode P100i-EL Cutting Tip 1.1mm 50A Cutting Tip 1.35mm 80A

16

17

2

Thank you for selecting the R-Tech PLASMA I-CUT 100P Inverter Plasma Cutter The PLASMA I-CUT 100P has many benefits over traditional transformer pla

Introduction The R-Tech PLASMA I-CUT 100P is a member of our field acclaimed family of welding products. Premium features include: 1. Inverter power

Safety Precautions Read entire section before starting installation WARNING! Electric Shock can kill Only qualified personnel should perform t

Electrical Installation WARNING! ELECTRIC SHOCK CAN KILL Machine grounding and High Frequency Interference Protection This plasma cutter must be grou

Turn the input power OFF at the mains switch & fuse box before working on this equipment. Have a qualified electrician install & service this

Connections for PLASMA I-CUT 100P Front machine connections Fig 2 1. Earth / Work piece connector Connect the earth lead to this connector. Inse

Controls and Settings Fig 1 1. Air pressure gauge This shows the air pressure as set by regulator at rear of machine. This should be set to 70PS